Sunday, December 8, 2013

A few more steps forward

Last night I created a support bracket to ensure my big-assed carb and air cleaner don't fall off while I'm running down the road.  It's just a simple 1/8" thick by 1" wide piece of mild steel with a mild z-bend in it and holes drilled to match.  It mounts onto the case bolt located at the bottom of the cylinder V and at the intake.  I plan on drilling a hole in it and inserting a grommet to run my fuel line through--this will stiffen the line a bit, keeping it from bouncing around and keep it safely away from the cylinders.

No comments:

Post a Comment